Release Time：2018/11/23Browsing Times：2970
Firstly, turn off the whole machine power. Remove Old Part: Open the lower right hand door panel, find the main controller board, like below. Unplug all connectors on the controller board, then rem...
Release Time：2017/03/22Browsing Times：2828
Firstly, disconnect the machine from its power source Disassembly procedure: Prepare M3/M4/M5 Allen Wrench Tips：Loosen in anticlockwise, tighten in clockwise. 1. Loosen two upper screws on the buc...
Release Time：2017/01/07Browsing Times：4247
Firstly, turn off the whole machine power. Remove Old Part: 1. Unplug the wire between laser tube and laser power supply and take out from the hole, like below. 2.unfix the tube. ① Cut the white ri...
Release Time：2017/01/05Browsing Times：3561
1.Please check before adjustment ①Hold and shake it to check if it becomes loose.(Can’t be wobble obviously) ②. In the back of X Axis Shaft have four rollers,both of them should locate on the rail....
Release Time：2016/12/21Browsing Times：4012
Please find a piece of 6mm acrylic (50*50mm),which used for testing the power of laser tube. Like below.
Release Time：2016/12/16Browsing Times：3738
There are two solutions： 1.Unfix the X Axis. Turn off the whole machine power. There are four screws for each side，loosen them then you can fine tuning the angle of the X Axis. Shown as bellow. D...
Release Time：2016/12/13Browsing Times：3937
Firstly, disconnect the machine from its power source. ① X-axis Motor Screw A: There are four screws A, for fixing the X motor; Screw B: It’s for adjusting the belt tension, please loosen the four ...
Release Time：2016/12/07Browsing Times：5449
There are three cases. 1. Two sides of the working table are not of the same height. Turn off the whole machine power, manually pull one of the belts of Z axis so as to adjust the up and down of th...