How to add Reverse compensation setting in software
Release Time：2020/05/13 General Question Browsing Times：840
Before you use the laser machine.
皇冠体育网Please remove the transparent bag from the front of honey comb plate.
The transparent bag has a set of USB flash drive, and an engraving test sample. The USB
flash drive stores software, manuals, libraries, etc… that you will need.
皇冠体育网Reverse Offset/Scan Offset compensation settings for this specific machine are included.
These settings needs to be entered into your RDWorks and/or LightBurn settings to
皇冠体育网 ensure the highest engraving quality.
For every laser machine, the setting is different. So please enter it to RDWorks/LightBurn
according to the card that came with the laser machine.
How to enter it in RDWorks/LightBurn
l In RDWorks
Please go to Config(s)>>System Setting>>Opitimize>>Scanning(Reverse compensation)>>Add,
皇冠体育网 then enter the Scan Offset compensation settings in>>OK.
Please enter all the settings on the Card according to the steps.
皇冠体育网After that, just need to close this page, the settings will be store automatically.
l In Lightburn
Please go to Device setting>>Enable Scanning Offset Adjustment>>Add>> enter the settings>>OK.
After that, select to “OK”, the settings will be store.