Air pump won’t work or no air assist when job starts
Release Time：2018/11/17 laser cutter machine Browsing Times：3215
Here are the reasons:
● Air compressor break down
How to check if air compressor break down, there’s a common way to connect it to the power directly using the power cable of chiller, then check if air compressor can be turn on normally, like below:
● Wrong setting
The air assist can be controlled by the layer parameter of software, please make sure you have “If Blowing” selected to YES, like below:
Note: If the Processing Mode is Cut, “If Blowing: Yes” must not be changed.
● The air valve is close
Make sure have the manual air valve opened（horizontal means open), like below:
- X-axis not moving at all
- Alarm message of LCD panel–Machine p...
- Y-axis not moving at all
- Engraving problem—the engraving quality is...
- Exhaust fan cannot extract smoke or dust
- Cutting problem– Some point of the s...
- Alarm message of LCD panel—Water error
- Alarm message of LCD panel—No enough exten...